Differences

This shows you the differences between two versions of the page.

--- en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane [2017/11/16 12:13] – [Internal forces and design factors] Alexandra Thiel
+++ en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane [2020/03/26 11:45] – Alexandra Thiel
@@ Line 1: / Line 1: @@
-FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)//
+====== Module "CLT-Plate loaded in plane" ======
-====== Module „CLT-Plate loaded in plane“ ======
 {{ en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane:gesamtscheibe.png?600 |CLT-Plate loaded in plane}}
@@ Line 14: / Line 12: @@
 ==== Cross section ====
-The input is the same as for the module [[en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam|Module "CLT-Plate 1D - Continuous beam"]].
+The input is the same as for the [[en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam|Module "CLT-Plate 1D - Continuous beam"]].
 ++++ Show description |
@@ Line 23: / Line 21: @@
 ==== Fire ====
-The input is the same as for the module [[en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam|Module „CLT-Plate 1D - Continuous beam“]].
+The input is the same as for the [[en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam|Module "CLT-Plate 1D - Continuous beam"]].
 ++++ Show description |
@@ Line 54: / Line 52: @@
 {{ en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane:zusammenfassung_scheibe.png |Summary of the results}}
+~~DISCUSSION~~