Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane [2017/11/16 12:10] – [Cross section] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane [2020/03/26 11:45] – Alexandra Thiel | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)// | + | ====== Module |
- | + | ||
- | ====== Module | + | |
{{ en: | {{ en: | ||
Line 14: | Line 12: | ||
==== Cross section ==== | ==== Cross section ==== | ||
- | The input is the same as for the module | + | The input is the same as for the [[en: |
++++ Show description | | ++++ Show description | | ||
Line 23: | Line 21: | ||
==== Fire ==== | ==== Fire ==== | ||
- | See [[modul_plate1d_continuousbeam#brand|Module CLT-Plate 1D - Continuous beam]] | + | The input is the same as for the [[en: |
+ | |||
+ | ++++ Show description | | ||
+ | {{section> | ||
+ | ++++ | ||
Fire left / right instead of fire above and below. | Fire left / right instead of fire above and below. | ||
==== Internal forces and design factors ==== | ==== Internal forces and design factors ==== | ||
- | In the tab „internal forces, stresses and utilization ratio“ it is possible to define the shear force in plane per unit length n< | + | In the tab „internal forces, stresses and utilization ratio“ it is possible to define the shear force in plane per unit length n< |
{{ en: | {{ en: | ||
Line 50: | Line 52: | ||
{{ en: | {{ en: | ||
+ | |||
+ | ~~DISCUSSION~~ |