Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane [2017/11/15 16:45] – [Eingabedaten] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane [2018/04/03 14:26] – Alexandra Thiel | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)// | + | ====== Module |
- | + | ||
- | ====== Module | + | |
{{ en: | {{ en: | ||
Line 12: | Line 10: | ||
* internal forces (design values) | * internal forces (design values) | ||
* definitions of design factors | * definitions of design factors | ||
- | ==== Querschnitt | + | ==== Cross section |
- | Siehe [[modul_plate1d_continuousbeam# | + | The input is the same as for the [[en: |
- | In diesem Modul kann die Querschnittsbreite nicht verändert werden. | + | ++++ Show description | |
- | ==== Brand ==== | + | {{section> |
+ | ++++ | ||
- | Siehe [[modul_plate1d_continuousbeam# | + | In this module it is not possible to change the cross sectional width. |
+ | ==== Fire ==== | ||
- | Brand links / rechts statt Brand oben / unten. | + | The input is the same as for the [[en: |
- | ==== Schnittgrößen und Bemessungsfaktoren ==== | + | |
- | In der Karteikarte „Schnittgrößen, | + | ++++ Show description | |
+ | {{section> en: | ||
+ | ++++ | ||
- | {{ clt: | + | Fire left / right instead of fire above and below. |
+ | ==== Internal forces and design factors ==== | ||
- | ===== Ergebnisse und Ausgabe ===== | + | In the tab „internal forces, stresses and utilization ratio“ it is possible to define the shear force in plane per unit length n< |
- | ==== Querschnittswerte | + | {{ en: |
+ | ===== Results and Output ===== | ||
- | In der Karteikarte „Querschnittswerte“ können die effektiven Steifigkeiten der Scheibe für den Vollquerschnitt und im Falle einer Brandbemessung auch für den Brandquerschnitt abgerufen werden. | + | ==== Cross section values ==== |
- | {{ clt: | + | The effective stiffnesses of a plate loaded in plane are given in the tab "cross section values" |
+ | |||
+ | {{ en:clt: | ||
<WRAP center round info 100%> | <WRAP center round info 100%> | ||
- | Die geringen Unterschiede zwischen der Dehnsteifigkeit | + | The small differences between the extensional stiffnesses |
</ | </ | ||
+ | ==== Summary of the results ==== | ||
- | ==== Zusammenfassung der Ergebnisse ==== | + | The calculated substituted thicknesses, stresses as well as utilization ratios of the two mechanisms |
- | + | ||
- | In der Karteikarte „Schnittgrößen, Spannungen und Ausnutzung“ werden die berechneten Ersatzdicken, | + | |
- | Zum Vergleich werden auch die Ausnutzungsgrade angelehnt an ETA-08/242 [(: | + | Furthermore, |
- | {{ clt: | + | {{ en:clt: |