Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane [2017/11/15 16:53] – [Cross section values] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_plate_in_plane [2018/04/03 14:26] – Alexandra Thiel | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)// | + | ====== Module |
- | + | ||
- | ====== Module | + | |
{{ en: | {{ en: | ||
Line 14: | Line 12: | ||
==== Cross section ==== | ==== Cross section ==== | ||
- | See [[modul_plate1d_continuousbeam# | + | The input is the same as for the [[en: |
- | In diesem Modul kann die Querschnittsbreite nicht verändert werden. | + | ++++ Show description | |
+ | {{section> | ||
+ | ++++ | ||
+ | |||
+ | In this module it is not possible to change the cross sectional width. | ||
==== Fire ==== | ==== Fire ==== | ||
- | See [[modul_plate1d_continuousbeam#brand|Module CLT-Plate 1D - Continuous beam]] | + | The input is the same as for the [[en: |
+ | |||
+ | ++++ Show description | | ||
+ | {{section> | ||
+ | ++++ | ||
- | Brand links / rechts statt Brand oben / unten. | + | Fire left / right instead of fire above and below. |
==== Internal forces and design factors ==== | ==== Internal forces and design factors ==== | ||
- | In the tab „internal forces, stresses and utilization ratio“ it is possible to define the shear force in plane per unit length n< | + | In the tab „internal forces, stresses and utilization ratio“ it is possible to define the shear force in plane per unit length n< |
{{ en: | {{ en: | ||
Line 39: | Line 45: | ||
</ | </ | ||
- | ==== Zusammenfassung der Ergebnisse | + | ==== Summary of the results |
- | In der Karteikarte „Schnittgrößen, Spannungen und Ausnutzung“ werden die berechneten Ersatzdicken, | + | The calculated substituted thicknesses, stresses as well as utilization ratios of the two mechanisms |
- | Zum Vergleich werden auch die Ausnutzungsgrade angelehnt an ETA-08/242 [(: | + | Furthermore, |
- | {{ clt: | + | {{ en:clt: |