Suche
Unten sind die Ergebnisse Ihrer Suche gelistet.
Volltextergebnisse:
- Module "Horizontal load distribution on shear walls"
- horizontal forces can be specified by entering H<sub>x</sub> and H<sub>y</sub> in [kN]. The position of the forces can be either user-defined (H<sub>x</sub> along the line o
- Module "CLT-Plate 1D - Continuous beam"
- name;number of layers n;layer thickness in [m] t<sub>1</sub> to t<sub>n</sub>;orientation of the layers o<sub>1</sub> to o<sub>n</sub> (0 or 90);name of material Example:\
- Module "Wall"
- llowing loads can be applied: * vertical load q<sub>d</sub> * horizontal load H<sub>d</sub> * load q<sub>⊥,d</sub> perpendicular to the wall {{ :en:clt:hotspot:software:cltdesigner:ma
- Module "Compression perpendicular to grain"
- data and design factors ==== The applied force F<sub>c,90</sub> (design value) in [N], as well as the design factors can be specified here. {{ en:clt:hots... ring the dimensions of the load surface (length l<sub>1,2</sub> in direction x and width w<sub>1,2</sub> in direction y) and the position. The position is d
- Module "CLT-Plate loaded in plane"
- define the shear force in plane per unit length n<sub>xy,d</sub>, as well as the design factors. The design method is based on a board width which is chosen... differences between the extensional stiffnesses D<sub>x</sub> and D<sub>y</sub> and the effective extensional stiffness EA<sub>ef</sub> in the module CLT-Pl
- Module "SHERPA CLT-Connector"
- es}} Furthermore, the modification coefficient k<sub>mod</sub> and the partial safety factor γ<sub>M</sub> must be specified. {{ en:clt:hotspot:software:cltdesigner:manual:modul_sherpa_clt_connector:
- Module „CLT-Plate 1D - Internal forces“
- tive cross section the required buckling factor k<sub>c</sub> needed for the verification is calculated automatically. {{ en:clt:hotspot:software:cltdesign