Search
You can find the results of your search below.
Fulltext results:
- Module "Horizontal load distribution on shear walls" @en:clt:hotspot:software:cltdesigner:manual
- the wall can be defined either by specifying the reference point (in the draft above, the point is set in the lower left corner at the φ = 0°; x<sub>ref</sub> and y<sub>ref</sub>) or by entering the center of mass (x<sub>C</sub> and y<sub>C</sub>), as wel
- sidebar
- |Spielwiese]] * [[help:syntax|Anleitung]] * [[refnotes|Referenzen]] * [[editor:todo|To Do's]] </showif> <ifauth @reviewer> * ++ Reviewer | {{indexme
- Modul "Gebäudeaussteifung" @clt:hotspot:software:cltdesigner:manual
- ezugspunktes (Punkt links unten bei φ = 0°; x<sub>ref</sub> und y<sub>ref</sub>) oder über Eingabe des Schwerpunktes (x<sub>C</sub> und y<sub>C</sub>) sowie
- Modul "BSP-Scheibe" @clt:hotspot:software:cltdesigner:manual
- h die Ausnutzungsgrade angelehnt an ETA-08/242 [(:ref:eta_08_0242_2009)] und ETA-09/0036 [(:ref:eta_09_0036_2009)] berechnet und angezeigt. {{ clt:hotspot:
- Module "CLT-Plate loaded in plane" @en:clt:hotspot:software:cltdesigner:manual
- tios, that were calculated based on ETA-08/242 [(:ref:eta_08_0242_2009)] and ETA-09/0036 [(:ref:eta_09_0036_2009)] are given. {{ en:clt:hotspot:software:cl
- Impressum @about
- Browserversion * verwendetes Betriebssystem * Referrer URL * Hostname des zugreifenden Rechners
- Module "Compression perpendicular to grain" @en:clt:hotspot:software:cltdesigner:manual
- introduction area A<sub>c,min</sub> describes the reference area in order to get the effective area A<s