Suche

Volltextergebnisse:

Module "CLT-Plate 1D - Continuous beam" @en:clt:hotspot:software:cltdesigner:manual

6 Treffer, Zuletzt geändert: vor 4 Jahren

cations of the maximum utilisation ratio and the governing combinations are compiled in the same way. {... tab "Utilisation" shows the distribution of the governing utilisation ratios along the beam. Areas in w... nutzungsgradverlauf.png?600 |Distribution of the governing utilisation ratios}} The tab "Stresses" shows the governing stresses resulting from the ULS verification.

Module "Compression perpendicular to grain" @en:clt:hotspot:software:cltdesigner:manual

2 Treffer, Zuletzt geändert: vor 4 Jahren

if so, if it is applied locally or continuously (over entire surface). If the load is applied loca... ribution of the effective area A_ef,max over the cross section (red line) as well as the assum

Module "Wall" @en:clt:hotspot:software:cltdesigner:manual

2 Treffer, Zuletzt geändert: vor 3 Jahren

internal forces n_y and n_xy over the wall length and m_y and v_y over the wall height are given in the tab "Distributio

Hilfecenter @clt:hotspot:software:cltdesigner

1 Treffer, Zuletzt geändert: vor 6 Jahren

l von SE, sondern nur noch im EE. [[https://stackoverflow.com/questions/43574426/how-to-resolve-java-la

Help center @en:clt:hotspot:software:cltdesigner

1 Treffer, Zuletzt geändert: vor 6 Jahren

r part of SE, but only in the EE. [[https://stackoverflow.com/questions/43574426/how-to-resolve-java-la

CLTdesigner - Versions and changes @en:clt:hotspot:software:cltdesigner

1 Treffer, Zuletzt geändert: vor 6 Monaten

7 | Full version, all company versions |- take over SLS limits in the settings (without pressing Ente

Module „CLT-Plate 1D - Internal forces“ @en:clt:hotspot:software:cltdesigner:manual

1 Treffer, Zuletzt geändert: vor 4 Jahren

e results ==== The stress distributions and the governing utilisation ratios are shown in the tab "Inte