Differences

This shows you the differences between two versions of the page.

--- en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_internalforces [2017/11/16 11:50] – [Cross section values] Alexandra Thiel
+++ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_internalforces [2020/03/26 11:45] (current) – Alexandra Thiel
@@ Line 1: / Line 1: @@
-FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)//
 ====== Module „CLT-Plate 1D - Internal forces“ ======
@@ Line 14: / Line 12: @@
   * specifications concerning stability
 ==== Cross section ====
+The input is the same as for the [[en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam|Module "CLT-Plate 1D - Continuous beam"]].
 ++++ Show description |
@@ Line 19: / Line 19: @@
 ++++
 ==== Fire ====
+The input is the same as for the [[en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam|Module „CLT-Plate 1D - Continuous beam“]].
 ++++ Show description |
@@ Line 33: / Line 35: @@
 ==== Cross section values ====
+The output is the same as for the [[en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam|Module „CLT-Plate 1D - Continuous beam“]].
 ++++ Show description |
@@ Line 47: / Line 51: @@
 {{ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_internalforces:detailscsverification.png?600 |Detailed results}}
+~~DISCUSSION~~