Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_internalforces [2017/11/16 11:49] – [Cross section] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_internalforces [2020/03/26 11:45] (current) – Alexandra Thiel | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)// | ||
- | |||
====== Module „CLT-Plate 1D - Internal forces“ ====== | ====== Module „CLT-Plate 1D - Internal forces“ ====== | ||
Line 14: | Line 12: | ||
* specifications concerning stability | * specifications concerning stability | ||
==== Cross section ==== | ==== Cross section ==== | ||
+ | |||
+ | The input is the same as for the [[en: | ||
++++ Show description | | ++++ Show description | | ||
Line 20: | Line 20: | ||
==== Fire ==== | ==== Fire ==== | ||
- | See [[modul_plate1d_continuousbeam#brand|Module CLT-Plate 1D - Continuous beam]] | + | The input is the same as for the [[en: |
+ | |||
+ | ++++ Show description | | ||
+ | {{section> | ||
+ | ++++ | ||
==== Type of calculation, | ==== Type of calculation, | ||
Line 32: | Line 36: | ||
==== Cross section values ==== | ==== Cross section values ==== | ||
- | See [[modul_plate1d_continuousbeam# | + | The output is the same as for the [[en: |
+ | |||
+ | ++++ Show description | | ||
+ | {{section> | ||
+ | ++++ | ||
==== Summary of the results ==== | ==== Summary of the results ==== | ||
Line 43: | Line 51: | ||
{{ en: | {{ en: | ||
+ | |||
+ | ~~DISCUSSION~~ |