Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revisionBoth sides next revision | ||
en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam [2020/03/24 12:44] – [Fire] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam [2020/03/24 12:51] – [Fire] Alexandra Thiel | ||
---|---|---|---|
Line 140: | Line 140: | ||
{{ en: | {{ en: | ||
- | For a user-defined cross section, options are given for specifying heat resistant adhesives, presence of grooves, and whether the layers are edge-glued. For proprietary | + | For a user-defined cross section, options are given for specifying heat resistant adhesives, presence of grooves, and whether the layers are edge-glued. For CLT products both values are set automatically and they cannot be changed. |
+ | |||
+ | Some manufacturers offer CLT elements with different adhesives, so instead of selecting "Heat resistant adhesive", | ||
+ | |||
+ | {{ en: | ||
The values k< | The values k< | ||
+ | |||
+ | In some approvals or design proposals a different charring rate is expected from the 2nd layer onwards. This will show up as follows: | ||
+ | |||
+ | {{ en: | ||
==== Vibrations ==== | ==== Vibrations ==== | ||