This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision |
en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam [2020/03/24 11:38] – [Optimization of layup] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam [2020/03/24 12:44] – [Fire] Alexandra Thiel |
---|
=== Optimization of layup === | === Optimization of layup === |
| |
Use the button {{en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:show_cs_optimization_button.png?130&nolink}} to display the window for layup optimization. | Use the button {{en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:show_cs_optimization_button.png?170&nolink}} to display the window for layup optimization. |
| |
{{ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:cs_optimization.png?600 |Layup optimization}} | {{ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:cs_optimization.png?600 |Layup optimization}} |
==== Fire ==== | ==== Fire ==== |
| |
By choosing "Fire above" and/or "Fire below" in the tab "Fire" a structural fire design has to be carried out. The "Fire duration" is specified in minutes and can be increased (or decreased) by increments of 30 minutes by pressing the up (or down) arrows, or defined by entering a specific duration between 0 minutes and 240 minutes in the allotted box. By ticking the box next to "Fire protection" a layer of fire protection is added to the plate, but the effective protection time of the protection layer needs to be defined. | By choosing "Fire above" and/or "Fire below" in the tab "Fire" a structural fire design has to be carried out. The "Fire duration" is specified in minutes and can be increased (or decreased) by increments of 30 minutes by pressing the up (or down) arrows, or defined by entering a specific duration between 0 minutes and 240 minutes in the allotted box. By ticking the box next to "Fire protection system" a layer of fire protection is added to the plate. Furthermore, the position ("above" and/or "below") must be declared and the parameters t<sub>ch</sub>, t<sub>f</sub>, k<sub>2</sub> and k<sub>3</sub> must be specified. In case the failure time of the fire protection system is equal to the time until the protected component starts to burn, the option "t<sub>f</sub> = t<sub>ch</sub>" shall be checked. |
| |
{{ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:fire.png |Input - Fire}} | {{ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:fire.png |Input - Fire}} |