Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam [2018/04/03 14:16] – [Vibrations] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam [2020/03/24 11:49] – [Optimization of layup] Alexandra Thiel | ||
---|---|---|---|
Line 37: | Line 37: | ||
The width of the CLT plate strips can be also defined in this field. The default value is set to 1 m. The thickness of the CLT plate is calculated automatically based on the thickness of the single layers. | The width of the CLT plate strips can be also defined in this field. The default value is set to 1 m. The thickness of the CLT plate is calculated automatically based on the thickness of the single layers. | ||
+ | |||
+ | The ratio of board thickness to board width can also be changed here. The default setting is 1:4. | ||
=== My CLT cross sections === | === My CLT cross sections === | ||
Line 50: | Line 52: | ||
* With {{: | * With {{: | ||
* With {{: | * With {{: | ||
+ | |||
+ | <WRAP center round info 100%> | ||
+ | **Syntax of the csv file** | ||
+ | |||
+ | name;number of layers n;layer thickness in [m] t< | ||
+ | |||
+ | Example: | ||
+ | Test layup; | ||
+ | </ | ||
+ | |||
+ | === My materials === | ||
+ | |||
+ | With the button {{: | ||
+ | |||
+ | {{ en: | ||
+ | |||
+ | * With {{: | ||
+ | * With {{: | ||
+ | * With {{: | ||
+ | * With {{: | ||
+ | * With {{: | ||
+ | |||
+ | <WRAP center round info 100%> | ||
+ | **Syntax of the csv file** | ||
+ | |||
+ | 1. row: description of the parameters\\ | ||
+ | 2. row: units of the parameters\\ | ||
+ | 3. row: value\\ | ||
+ | delimiter: ";" | ||
+ | |||
+ | Example: | ||
+ | Name; | ||
+ | ; | ||
+ | Mat 1; | ||
+ | </ | ||
+ | |||
+ | The user-defined materials are then displayed in the material selection list. | ||
+ | |||
+ | {{ en: | ||
+ | |||
+ | === Optimization of layup === | ||
+ | |||
+ | Use the button {{en: | ||
+ | |||
+ | {{ en: | ||
+ | |||
+ | With the help of this tool, the possible layups can be determined for the given system and load situation. The optimization can be restricted with regard to producers, number of layers or by means of limits for the panel thickness. Furthermore, | ||
+ | |||
+ | With the buttons " | ||
+ | |||
+ | The possible setups are then displayed in the table and the selected setup can be transferred to the main window by clicking the " | ||
==== Loads ==== | ==== Loads ==== | ||
Line 98: | Line 151: | ||
For the vibration verification the following specifications are of importance: | For the vibration verification the following specifications are of importance: | ||
- | * high oder normal requirements? | + | * high or normal requirements? |
* modal damping factor | * modal damping factor | ||
* consideration of the screed (concrete topping) stiffness | * consideration of the screed (concrete topping) stiffness |