en:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
en:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain [2018/04/03 17:13] Alexandra Thielen:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain [2020/03/26 11:45] (current) Alexandra Thiel
Line 27: Line 27:
 In addition to plate dimensions, the analysis also considers the way the lamellas are joined into individual layers. Regarding to the joining of the outer layers, one should differ: In addition to plate dimensions, the analysis also considers the way the lamellas are joined into individual layers. Regarding to the joining of the outer layers, one should differ:
   * side gluing of lamellas,   * side gluing of lamellas,
-  * assembly without adhesive where lamellas are placed side by side without the sheduled gaps or the expected occurence of cracks and +  * assembly without adhesive where lamellas are placed side by side without the scheduled gaps or the expected occurrence of cracks and 
-  * possible occurence of gaps or cracks wider than 1 mm.+  * possible occurrence of gaps or cracks wider than 1 mm.
 ==== Load data and design factors ==== ==== Load data and design factors ====
  
Line 68: Line 68:
 {{page> :clt:design:plate_loaded_out_of_plane:compression:model_brandner_schickhofer_2014&inline&permalink}} {{page> :clt:design:plate_loaded_out_of_plane:compression:model_brandner_schickhofer_2014&inline&permalink}}
 ++++ ++++
 +
 +~~DISCUSSION~~
  • en/clt/hotspot/software/cltdesigner/manual/modul_compression_perpendicular_to_grain.1522768435.txt.gz
  • Last modified: 2018/04/03 17:13
  • by Alexandra Thiel