Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain [2018/04/03 16:51] – [Load configuration] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain [2020/03/26 11:45] (current) – Alexandra Thiel | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)// | ||
- | |||
====== Module " | ====== Module " | ||
Line 29: | Line 27: | ||
In addition to plate dimensions, the analysis also considers the way the lamellas are joined into individual layers. Regarding to the joining of the outer layers, one should differ: | In addition to plate dimensions, the analysis also considers the way the lamellas are joined into individual layers. Regarding to the joining of the outer layers, one should differ: | ||
* side gluing of lamellas, | * side gluing of lamellas, | ||
- | * assembly without adhesive where lamellas are placed side by side without the sheduled | + | * assembly without adhesive where lamellas are placed side by side without the scheduled |
- | * possible | + | * possible |
==== Load data and design factors ==== | ==== Load data and design factors ==== | ||
Line 38: | Line 36: | ||
==== Load configuration ==== | ==== Load configuration ==== | ||
- | |||
- | FIXME | ||
The load situation is described by specifying the load introduction above and below. Thereby, one can define if the load is even applied, and if so, if it is applied locally or continuously (over entire surface). | The load situation is described by specifying the load introduction above and below. Thereby, one can define if the load is even applied, and if so, if it is applied locally or continuously (over entire surface). | ||
Line 49: | Line 45: | ||
==== Calculation options ==== | ==== Calculation options ==== | ||
- | In den Berechnungsoptionen können die Lastausbreitungswinkel für Längslagen | + | In the calculation options, the load distribution angles for longitudinal layers |
{{ en: | {{ en: | ||
===== Results and Output ===== | ===== Results and Output ===== | ||
- | Die minimale Lasteinleitungsfläche beschreibt die Bezugsfläche, | + | The minimum load introduction area A< |
- | Die Ausnutzung auf Querdruck wird durch den Ausnutzungsgrad | + | The utilisation ratio for compression perpendicular to grain is indicated by η< |
{{ en: | {{ en: | ||
- | In der folgenden Skizze wird der Verlauf der effektiven Fläche | + | The following figure shows the distribution of the effective area A< |
{{ en: | {{ en: | ||
Line 72: | Line 68: | ||
{{page> : | {{page> : | ||
++++ | ++++ | ||
+ | |||
+ | ~~DISCUSSION~~ |