Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
en:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain [2018/04/03 16:58] – [Calculation options] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain [2018/11/09 10:24] – Alexandra Thiel | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)// | ||
- | |||
====== Module " | ====== Module " | ||
Line 29: | Line 27: | ||
In addition to plate dimensions, the analysis also considers the way the lamellas are joined into individual layers. Regarding to the joining of the outer layers, one should differ: | In addition to plate dimensions, the analysis also considers the way the lamellas are joined into individual layers. Regarding to the joining of the outer layers, one should differ: | ||
* side gluing of lamellas, | * side gluing of lamellas, | ||
- | * assembly without adhesive where lamellas are placed side by side without the sheduled | + | * assembly without adhesive where lamellas are placed side by side without the scheduled |
- | * possible | + | * possible |
==== Load data and design factors ==== | ==== Load data and design factors ==== | ||
Line 52: | Line 50: | ||
===== Results and Output ===== | ===== Results and Output ===== | ||
- | Die minimale Lasteinleitungsfläche beschreibt die Bezugsfläche, | + | The minimum load introduction area A< |
- | Die Ausnutzung auf Querdruck wird durch den Ausnutzungsgrad | + | The utilisation ratio for compression perpendicular to grain is indicated by η< |
{{ en: | {{ en: | ||
- | In der folgenden Skizze wird der Verlauf der effektiven Fläche | + | The following figure shows the distribution of the effective area A< |
{{ en: | {{ en: |