en:clt:hotspot:software:cltdesigner:manual

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
en:clt:hotspot:software:cltdesigner:manual [2021/07/22 15:50] Alexandra Thielen:clt:hotspot:software:cltdesigner:manual [2021/07/22 15:50] Alexandra Thiel
Line 61: Line 61:
 The [[en:clt:hotspot:software:cltdesigner:manual:modul_sherpa_clt_connector|Module „SHERPA CLT-Connector“]] calculates connections of cross laminated timber elements with the SHERPA CLT-Connector according to the European Technical Assessment ETA-18/0083. The [[en:clt:hotspot:software:cltdesigner:manual:modul_sherpa_clt_connector|Module „SHERPA CLT-Connector“]] calculates connections of cross laminated timber elements with the SHERPA CLT-Connector according to the European Technical Assessment ETA-18/0083.
  
-The [[clt:hotspot:software:cltdesigner:manual:modul_wall|Module „Wall“]] offers the required verifications for the ultimate limit state (ULS) of walls under vertical and horizontal loads as well as wind perpendicular to the wall plane (cold and hot dimensioning).+The [[en:clt:hotspot:software:cltdesigner:manual:modul_wall|Module „Wall“]] offers the required verifications for the ultimate limit state (ULS) of walls under vertical and horizontal loads as well as wind perpendicular to the wall plane (cold and hot dimensioning).
 ==== Menu bar ==== ==== Menu bar ====
  
  • en/clt/hotspot/software/cltdesigner/manual.txt
  • Last modified: 2022/05/04 14:20
  • by Alexandra Thiel