This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision |
| en:clt:hotspot:software:cltdesigner:manual [2021/07/22 14:11] – [Modules] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual [2021/07/22 15:50] – Alexandra Thiel |
|---|
| <WRAP third column> | <WRAP third column> |
| <wrap center info 100%> | <wrap center info 100%> |
| Version 7.0 | Version 8.0 |
| </wrap> | </wrap> |
| </WRAP> | </WRAP> |
| The [[en:clt:hotspot:software:cltdesigner:manual:modul_sherpa_clt_connector|Module „SHERPA CLT-Connector“]] calculates connections of cross laminated timber elements with the SHERPA CLT-Connector according to the European Technical Assessment ETA-18/0083. | The [[en:clt:hotspot:software:cltdesigner:manual:modul_sherpa_clt_connector|Module „SHERPA CLT-Connector“]] calculates connections of cross laminated timber elements with the SHERPA CLT-Connector according to the European Technical Assessment ETA-18/0083. |
| |
| /*The [[clt:hotspot:software:cltdesigner:manual:modul_wall|Module „Wall“]] offers the required verifications for the ultimate limit state (ULS) of walls under vertical and horizontal loads as well as wind perpendicular to the wall plane (cold and hot dimensioning).*/ | The [[clt:hotspot:software:cltdesigner:manual:modul_wall|Module „Wall“]] offers the required verifications for the ultimate limit state (ULS) of walls under vertical and horizontal loads as well as wind perpendicular to the wall plane (cold and hot dimensioning). |
| ==== Menu bar ==== | ==== Menu bar ==== |
| |