Module "Web plates" [BSP Wiki]

Diese Seite ist nicht editierbar. Sie können den Quelltext sehen, jedoch nicht verändern. Kontaktieren Sie den Administrator, wenn Sie glauben, dass hier ein Fehler vorliegt.
~~NOTOC~~
====== Module "Web plates" ======

{{ :en:clt:hotspot:software:cltdesigner:manual:modul_webplate:gesamthohlraumdecke.png |Module Web plates}}

===== Input data =====

The input is divided into:

  * general information about the project and the considered structural element
  * definitions of the structural system
  * definitions of the cross section
  * input of the loads
  * informations about vibration parameters
  * calculation options

==== General ====

{{page> :en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam#general&inline&permalink&noheader}}

==== Structural system ====

{{page> :en:clt:hotspot:software:cltdesigner:manual:modul_tbeam_new#structural_system&inline&permalink&noheader}}

==== Cross section ====

In this module, the cross-section is defined by selecting a product.

{{ :en:clt:hotspot:software:cltdesigner:manual:modul_webplate:cs.png?411 |Cross section web plates}}
==== Loads ====

{{page> :en:clt:hotspot:software:cltdesigner:manual:modul_tbeam_new#loads&inline&permalink&noheader}}

==== Fire ====

{{page> :en:clt:hotspot:software:cltdesigner:manual:modul_tbeam_new#fire&inline&permalink&noheader}}

==== Vibrations ====

{{section> :en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam#vibrations&inline&permalink&noheader}}
===== Results and Output =====

==== Cross section values ====

On the tab "cross-section values", the effective width, the center of gravity as well as the bending and shear stiffness of the T-beam at the supports and in between are shown.

{{ :en:clt:hotspot:software:cltdesigner:manual:modul_webplate:querschnittswerte_feldbereich.png |Cross section values}}

The button {{:clt:hotspot:software:cltdesigner:manual:modul_tbeam_new:info_button.png?40&nolink}} can be used to display the stiffness values of the CLT panel, the glulam beam and the shear spring, which are the input parameters for determining the effective width.

{{ :en:clt:hotspot:software:cltdesigner:manual:modul_tbeam_new:querschnittswerte_bsp_bsh.png?811 |Stiffness values of the CLT panel, the glulam beam and the shear spring}}
==== Summary of the results ====

{{page> :en:clt:hotspot:software:cltdesigner:manual:modul_tbeam_new#summary_of_the_results&inline&permalink&noheader}}