Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam [2024/10/10 18:04] – [Loads] Alexandra Thiel
+++ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam [2024/10/11 11:54] (aktuell) – [Cross section] Alexandra Thiel
@@ Zeile 1: / Zeile 1: @@
 ====== Module "CLT-Plate 1D - Continuous beam" ======
-{{ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:modul_continuousbeam.png?600 |CLT-Plate 1D - Continuous beam}}
+{{ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:modul_continuousbeam.png |CLT-Plate 1D - Continuous beam}}
 ===== Input data =====
@@ Zeile 34: / Zeile 34: @@
 If a user-defined cross section is entered, the thickness and orientation of each layer can be changed. Furthermore, the material can be changed for all layers. The thickness of each layer has to be within the range of 6.0 mm to 45 mm. In the case of proprietary CLT products, the strength class of lumber and the orientation can be changed. If the orientation is changed, the whole cross section is rotated.
-{{ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:querschnitt.png |Input - Cross section}}
+{{ en:clt:hotspot:software:cltdesigner:manual:modul_plate1d_continuousbeam:querschnitt.png?400 |Input - Cross section}}
 The width of the CLT plate strips can be also defined in this field. The default value is set to 1 m. The thickness of the CLT plate is calculated automatically based on the thickness of the single layers.