Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain [2018/04/03 17:13] – [Results and Output] Alexandra Thiel
+++ en:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain [2025/06/16 17:53] (aktuell) – [Implemented calculation methods] Alexandra Thiel
@@ Zeile 1: / Zeile 1: @@
-FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)//
 ====== Module "Compression perpendicular to grain" ======
@@ Zeile 29: / Zeile 27: @@
 In addition to plate dimensions, the analysis also considers the way the lamellas are joined into individual layers. Regarding to the joining of the outer layers, one should differ:
   * side gluing of lamellas,
-  * assembly without adhesive where lamellas are placed side by side without the sheduled gaps or the expected occurence of cracks and
+  * assembly without adhesive where lamellas are placed side by side without the scheduled gaps or the expected occurrence of cracks and
-  * possible occurence of gaps or cracks wider than 1 mm.
+  * possible occurrence of gaps or cracks wider than 1 mm.
 ==== Load data and design factors ====
@@ Zeile 61: / Zeile 59: @@
 {{ en:clt:hotspot:software:cltdesigner:manual:modul_compression_perpendicular_to_grain:graphic_ergebnisse.png |Distribution of the effective Area}}
-===== Implemented calculation methods =====
+/*===== Implemented calculation methods =====
 ++++ Compression perpendicular to grain - Verification |
@@ Zeile 70: / Zeile 68: @@
 {{page> :clt:design:plate_loaded_out_of_plane:compression:model_brandner_schickhofer_2014&inline&permalink}}
 ++++
+~~DISCUSSION~~
+*/